UTICA BOILERS MGB Series II/MGC Series Manual de Instalação descarregar pdf (Página 2)

Figure 3 - Install Pilot Assembly

WARNING

Fire, burn hazard. Do not operate boiler without

burner doors in place. Failure to follow these

instructions could result in death or serious injury.

NOTE: Refer to Figure 6 ﬁ nal pilot tubing conﬁ guration.

11.

Remove pilot assembly from box. Spin assembly so it

enters base between lower front panel and top of base.

See Figure 3.

12.

Push assembly into base. If needed, slide pilot tube

and spark wire (or thermocouple) through hole in lower

front panel. See Figure 4.

13.

Rotate pilot assembly until it is vertical and holes in

pilot assembly line up with pilot mounting holes in

top of base. Verify base insulation is over top of pilot

bracket, not in between bracket and base top. See

Figure 5.

14.

Fasten assembly using screws provided. After

fastening assembly, reach in base above bracket and

verify insulation is laying ﬂ at against base front.

15.

Verify pilot assembly is correctly angled; at right angle

with top of base.

16.

Install burner tubes in base by sliding crimped end into

slots in back of base. Rest front of burner on oriﬁ ces.

Replace upper burner door. See Figure 5.

17.

Final pilot tubing conﬁ guration after completion all

steps see Figure 6.

18.

Refer to Installation, Operation and Maintenance

Manual and labels afﬁ xed to boiler for lighting

instructions.

Figure 4 - Installed Pilot Assembly (3 Section Shown)

Figure 5 - Install Burner Door and Tubes

(3 Section Shown)

Figure 6 - Series 2 Final Pilot Tubing Conﬁ guration

(2 Section Shown)

KIT INSTALLATION INSTRUCTIONS

ECR International, Inc.

2201 Dwyer Avenue, Utica NY 13504-4729

web site: www.ecrinternational.com

1 2

Comentários a estes Manuais

Sem comentários

UTICA BOILERS MGB Series II/MGC Series Manual de Instalação Página 2

Comentários a estes Manuais

Manuais e produtos relacionados com não UTICA BOILERS MGB Series II/MGC Series